If contaminants are not removed before use, the adhesion ability of Metal Protector may be compromised. Protect unintended surfaces. Always test in a small, inconspicuous area before application. Make sure all product residues are completely removed from the surface before the application of the Metal Protector.
Apply the product with a sponge roller, paintbrush, or sprayer. This product is similar to the application of paint. This product can be diluted with water for spray applications.
For a highly polished and enhanced surface, apply the product evenly to the surface using a fine mist sprayer such as a HPLV (High-Pressure, Low-Volume) sprayer. A fine sponge or paintbrush can also be used but may leave brush strokes on the surface.
The coating will begin to cure within 15 minutes and will not fully cure for 48 hours. No liquids may come into contact with the surface during that time.
MAINTENANCE
In most circumstances, protected metal surfaces can be cleaned using only deionized water.
WARRANTIES
The information provided by Presto for the safe and effective use of this product, and all of our products, is believed to be good and accurate. However, due to the many different possible applications of this product, careful considerations should be made when selecting its suitability for each surface.
The information provided should never be substituted for individual testing to ensure the product’s compatibility with each surface intended for use. The purchaser shall assume all responsibility for determining the suitability of this product. When used as intended, this product will perform as stated. No other warranty can be made for this product, verbally or written.
Presto warrants this product to be free from defects. If this product is found to be defective, we will provide a sufficient amount to replace the defective product.
Reviews
There are no reviews yet.