Glass maintenance

Scumfree

The window cleaning concentrate that leaves no oily residue, so it cleans protected glass without feeding the staining that protection was meant to stop.

Dilution
Varies / by condition
Residue
Dries to a powder
Safe on
Glass, metal and stone coatings
Use
Maintenance / not blow-and-go
Presto Scumfree window cleaning concentrate, one quart bottle

Order

You will also need

This is a concentrate that goes into a bucket of water, not a ready-to-use spray. How much depends on how dirty the glass is, so there is no fixed dilution and no coverage figure.

  • Window cleaning bucket, squeegee and brushNot supplied
  • Microfiber towelsNot supplied
  • Deionized waterRecommended
Before you start

This product carries no GHS signal word on its safety data sheet, which is why its info chart reads User Friendly: Yes. It does carry a California Proposition 65 warning, and it is labelled for industrial use only.

California Proposition 65 warning

This material contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm: 1,4-Dioxane (CAS 123-91-1) and Ethylene Oxide (CAS 75-21-8). Taken from section 15 of the safety data sheet.

What to know

  • For industrial use only. Keep out of reach of children, and read all label instructions before handling the product.
  • Limit bodily contact, as with any cleaning product, even though this one is formulated to be an employee-safe alternative.
  • It dries white. Excess material has to be removed or the residue shows, and it shows most on dark surfaces.
  • Do not let it reach a drain, the ground or a waterway. The safety data sheet classes it as harmful to aquatic life with long-lasting effects and says not to dump it into sewers or waterways. On a multi-storey facade that means capturing the dirty mixture rather than letting it run down the building.
  • Test compatibility on any surface before committing to it. The purchaser carries responsibility for deciding the product suits the surface.

Hazard rating

  • Health 1
  • Flammability 0
  • Reactivity 0
  • HMIS scale 0 to 4, from the safety data sheet

Open the safety data sheet

Where this sits in the glass system

This is the last step, and the one that decides whether the first two were worth paying for. Ordinary window cleaning detergents leave an oily surfactant residue, and that residue is what glues contamination to the glass and starts the staining again.

Step 1 · Restore

Glass ReSurfacer Final Polish

Takes the existing corrosion, scratches and staining off the glass and leaves a reflective, distortion-free surface.

View product

Step 2 · Protect

Glass Defender

Seals the restored glass for five years against corrosion, staining and water erosion.

View product

Step 3 · Maintain · you are here

Scumfree

Cleans protected glass without damaging the coating and without leaving the oily film that restarts the staining. Designed by window cleaners for high-rise work.

Sometimes you need less than you think. On glass protected with Glass Defender, there are cases where deionized water alone is enough and no concentrate is needed at all. The dilution depends on the condition of the surface, and using more than necessary is the common mistake.

How to apply it

  1. 1

    Mix it, lightly

    Add Scumfree to a five gallon bucket of water, ideally deionized water, with clean window cleaning tools. How much you need depends on the condition of the surface. Avoid using more than necessary, and on Glass Defender protected glass check whether plain deionized water does the job first.

  2. 2

    Apply and scrub

    Apply the mixture to the glass with a window cleaning brush and scrub the window to loosen all the surface contamination.

  3. 3

    Squeegee before it dries

    Use a squeegee with a new, sharp rubber blade to take the solution off the glass before it dries. Where you can, hold the brush horizontally underneath the squeegee so the excess mixture is caught and held in the brush rather than running loose.

  4. 4

    Wipe the edges and frames

    Use a microfiber towel to take the excess off the window edges, the frames and any adjacent surfaces. The product dries white, so anything left behind will be visible, especially against a dark surface.

  5. 5

    Catch the runoff

    Scumfree is designed not to cause staining, but capture as much of the dirty mixture as you can rather than letting it run down the facade. The safety data sheet also says to keep it out of drains and waterways.

Equipment needed

  • Window cleaning bucket, squeegee and brush
  • Microfiber towels
  • Deionized water, recommended

What it is not for

This is not a blow-and-go window cleaning product. It is built for carefully cleaning glass that carries a protective coating, on buildings where the cost of restarting the staining cycle is measured in storeys.

Technical details

Scumfree Professional Window Cleaning Concentrate
CoverageNot published. It is a concentrate and the dilution depends on the condition of the surface.
Sold as1 quart bottle, or a 12 quart case
SolventWater based
FlammableNo
User friendlyYes no signal word on the safety data sheet
Economically efficientYes
Environmentally friendlyYes
BiodegradableYes
ColourClear
SmellNone
ResidueDries to a powder, leaving no oily film
Suitable surfacesGlass, metal and stone, including surfaces carrying protective coatings
RemovesOil, soap scum, dust, dirt and minerals including silicates, calcium, lime, silica and magnesium
RegulatoryCarries a California Proposition 65 warning. Labelled for industrial use only.
Why it is worth using over a dish detergent. Designed for professional high-rise window cleaning. Leaves no oily residue and dries to a powder, so windows stay clean longer. Will not damage glass, metal or stone protective coatings, and will not jeopardise the warranties on coatings applied to adjacent surfaces. Biodegradable, and a safer alternative to the dishwashing detergents the window cleaning industry has long used.
Warranty terms in full

The information provided by Presto for the safe and effective use of this product, and all of our products, is believed to be good and accurate. However, due to the many different possible applications of this product, careful consideration should be made when selecting its suitability for each surface.

The information provided should never be substituted for individual testing to ensure the compatibility of the product with each surface intended for use. The purchaser shall assume all responsibility for determining the suitability of this product. When used as intended, this product will perform as stated. No other warranty can be made for this product, verbally or in writing.

Presto warrants this product to be free from defects. In the event this product is found to be defective, we will provide a sufficient amount of product to replace the defective product.